Every time I save, DC creates an .aec file, an .arb file, a .dbk file and an .arf file.
My manual goes into a lot of detail about how DC creates these files but I can't find anywhere that tells me how to open any of them. Interesting that a search for the above initials retrieves absolutely nothing from the forum.
I had a crash today and after rebooting, DC will not open my file. Right now I am at risk of losing two days' work. My error message is internal diagnostics fault 10 Error from: 74.
17 years of DataCAD and never had this happen. Lots of crashes but the file always opens after restarting DC.
The crash occurred when trying to erase a new poison entity (See my post March 16 this year).
Josh suggested last time if I posted the file here, he might have time to take a look at so will try that route. If you can open the file, the poison is on the layer "steel". Note that I tried to Repair but got the same error message.
Looking for any advice.
Thanks
joe
My manual goes into a lot of detail about how DC creates these files but I can't find anywhere that tells me how to open any of them. Interesting that a search for the above initials retrieves absolutely nothing from the forum.
I had a crash today and after rebooting, DC will not open my file. Right now I am at risk of losing two days' work. My error message is internal diagnostics fault 10 Error from: 74.
17 years of DataCAD and never had this happen. Lots of crashes but the file always opens after restarting DC.
The crash occurred when trying to erase a new poison entity (See my post March 16 this year).
Josh suggested last time if I posted the file here, he might have time to take a look at so will try that route. If you can open the file, the poison is on the layer "steel". Note that I tried to Repair but got the same error message.
Looking for any advice.
Thanks
joe
Attachments
(4.61 MiB) Downloaded 350 times