A collection of training videos for DataCAD.
#66151 by fsoliver
Tue Mar 24, 2015 4:11 pm
I tried this with a DataCAD plan but the o2C Interactive image didn't cut the walls at the windows and so you were looking at the tops of the wall. I tried to walk forward down into the plan to see if that would cut the walls at the center of the windows and that didn't work. I also did a clip cube in DataCAD at the windows and that didn't come through to o2c. Does anyone have any idea how this can be done in these programs?
#66152 by Mark F. Madura
Tue Mar 24, 2015 4:16 pm
The trick is to widen your cone of vision. In plan view, toggle to perspective viewing, increase your cone of vision, then toggle to parallel viewing.
Keep doing this until you get the clipping plane where you want it.

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984