Topic Title

What I would really like to see is a button in Sunshader that sets the view to match that current in DataCad.

Then the ability to save that at say 4096 wide.

I guess I would settle for doing the same thing in o2c............

[Mark F. Madura]

What I would really like to see is a button in Sunshader that sets the view to match that current in DataCAD.

Then the ability to save that at say 4096 wide.

I guess I would settle for doing the same thing in o2c............

We have done some work to get views synchronized between DataCAD, o2c, and the Sunshader. Unfortunately, the view matrices for each are completely different so it will take a bit of effort for us to get this worked out.

As for the output resolution of the Sunshader, you can specify the width via File, Save Image, Image Resolution. 4096 should be no problem; support for higher values will depend upon your graphics hardware.