Hello,
On plain ol' 2D doors and windows, it would be great to "disconnect" the Draw Jamb setting between these. I like to draw jambs on windows, but not on doors, so having to switch this on/off is a small inconvenience.
I wish I could work with Smart Walls, but it seems like usually these are hard to adapt to the situation. At the moment, I am redrawing plans from old prints, so not knowing what the walls are makes it easier to just draw 2D walls. Also, we use a layer for the exterior walls, and another one for the interior walls, and that complicated things for Smart Walls.
On plain ol' 2D doors and windows, it would be great to "disconnect" the Draw Jamb setting between these. I like to draw jambs on windows, but not on doors, so having to switch this on/off is a small inconvenience.
I wish I could work with Smart Walls, but it seems like usually these are hard to adapt to the situation. At the moment, I am redrawing plans from old prints, so not knowing what the walls are makes it easier to just draw 2D walls. Also, we use a layer for the exterior walls, and another one for the interior walls, and that complicated things for Smart Walls.