Page 16 of 16

multiple symbol browsers

PostPosted: Wed Oct 14, 2009 6:06 pm
by Robert Peters
You can have two symbol browsers open, but one of them is a browser and one is a template. It works well with two monitors.

Scale Type Stacked Fractions Override

PostPosted: Tue Aug 17, 2010 3:39 am
by joshhuggins
Would be nice if when changing a dimension Scale Type to Arch or Inch/Frac. in the Dimension Properties dialog, that it would read the current setting for the Stacked Fractions from the drawing and use that setting instead of defaulting to off. Or an ini setting to set the default :twisted:
I know my favorite Troglodyte loves ini settings. Not a priority by any means David! Chill homie

PostPosted: Tue Aug 17, 2010 6:53 am
by Tony Blasio
I agree. This would be a nice improvement.

PostPosted: Thu Aug 26, 2010 4:40 pm
by joshhuggins
It would be nice if when using Move, Area it would move MText when the area crosses over the insertion point, that it would move the MText. The Stretch command does this now, and it's nice not having to put the area around the whole MText box.

PostPosted: Fri Aug 27, 2010 7:23 am
by Miguel Palaoro
I second it, Cousin.

Nice improvement!

Re: Plot Scale Stamps

PostPosted: Tue Sep 21, 2010 4:57 pm
by Mark F. Madura
joshhuggins wrote:It would be so nice to have a plot scale stamp that could read the current plot scale.


Please see my recent post on the subject.

Thank You,


PostPosted: Tue Sep 21, 2010 8:15 pm
by joshhuggins
Sounds good can't wait to check it out. Thanks gentlemen. :D