We're persistently getting text that is changing size and it's due to the 'new' Lock Size command. At this stage it's not a feature we wish to use but it seems to have found its way into common commands. If I Alt+I SetALL on an existing text which does not have Lock Size set on, then use Alt T (or pick Text) to go to the text command, Lock Size is set ON. It would be beneficial for future releases to keep the Alt+I/Alt T as it used to be - without the Lock Size set to ON and leave this feature as an option to use rather than being permanently set each time the keyboard command is invoked. Thanks.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com