Fillet
Posted: Thu Oct 03, 2013 5:05 amparallel lines using the first line picked as the control, with the resulting arc having a radius of one half the distance between the lines.
Page 1 of 1
Posted: Thu Oct 03, 2013 5:05 amRe: Fillet
Posted: Thu Oct 03, 2013 7:39 amArc/Tangent does this!
Re: Fillet
Posted: Thu Oct 03, 2013 7:46 amArc/tangent is close or is the same if the line ends are the same. If not, then it is tangent only at one end.
Thanks though.
Woody
Thanks though.
Woody
Re: Fillet
Posted: Thu Oct 03, 2013 11:07 amIf you have Object Snap\Tangent toggled on, it will work if you start on the shorter line. To start with the longer line, you can use the Shift-Snap Get X or Get Y to finish, and then 2-Line Trim to connect the arc to the shorter line.