What features would you like to see added to a future version of DataCAD?
#61851 by wwwylie
Sun Oct 13, 2013 2:09 am
I think it would be really useful if KnockOuts were enhanced in two ways:
    1. KnockOut drawing scale option in ini: allow the Knockout scale to be based in the drawing scale (+/- inches or millimeters) instead of based on a percentage of the entity's size. It also be a KnockOut "offset" and not have separate X & Y values. KnockOut offset could then be added to entities that scale currently is not, like polylines.
    2. Line knockout: with the new KnockOut scale set to drawing scale it would be nice to be able to apply knockouts to lines so that there was a "halo" around them. I actually prefer this for smart arrows so that I could have a knockout that was not only bigger than the arrowhead, but also the leader line.

Who is online

Users browsing this forum: No registered users and 9 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984