What features would you like to see added to a future version of DataCAD?
#62450 by damian
Tue Nov 19, 2013 2:54 pm
When you use "3D Knife", immediately after making the cut (remove, uplift, etc.) appears an interesting information with the cubic volume of the cut made​​. "Total cut and total fill."
It would be interesting and useful to be able to save this information or put them on the drawing and use when you need them.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984