forum.datacad.com

It would be very helpful if the dynamic flip and rotate options could be added to Copy/Drag and Move Drag.

Another way to achieve this is to copy/paste. Then you'll have access to all of the symbol insert commands.

Yes on both comments. I try to remember to use copy and paste when I know I am going to be doing multiple locations, but too often I am jamming along and start the copy/move drag command thinking (or most of the time not thinking) that it's only for one spot and then realize I need more locations that need mirroring/flipping. It would be handy to have it in the copy and move locations as well for these times.