Hello,
When applied the [Identify] command, a 'Stamp' is not identified like an entity with that quality (stamp). But it actually is. You can change the condition that generated the information and it will update the content.
This allows me to infer that it has one special 'dynamic link' with the source information.
So, my wish would be that this same engine (dynamic link), that keeps a stamp updated, would be used also for other features, like:
A) On a uni-directional basis:
A table with valuable informations for editing purposes, like:
B) Later, on a bi-directional function:
This could be transformed on a 'Control Panel' which would allow the 'reverse' edition function, for making bulk revisions on the drawing like:
• a whole set or type of entities;
• by single layer or whole drawing;
• by specific selected entities;
• by X-Ref'ed drawing or only the 'Host';
Just for some dreams.
Thanks,
Miguel
When applied the [Identify] command, a 'Stamp' is not identified like an entity with that quality (stamp). But it actually is. You can change the condition that generated the information and it will update the content.
This allows me to infer that it has one special 'dynamic link' with the source information.
So, my wish would be that this same engine (dynamic link), that keeps a stamp updated, would be used also for other features, like:
A) On a uni-directional basis:
A table with valuable informations for editing purposes, like:
B) Later, on a bi-directional function:
This could be transformed on a 'Control Panel' which would allow the 'reverse' edition function, for making bulk revisions on the drawing like:
• a whole set or type of entities;
• by single layer or whole drawing;
• by specific selected entities;
• by X-Ref'ed drawing or only the 'Host';
Just for some dreams.
Thanks,
Miguel
Miguel J. Palaoro • Porto Alegre • Brasil
[DataCAD user since V.4 • Languages: English & Português • Scale Type/Unit: Meter-ABNT]
[DataCAD user since V.4 • Languages: English & Português • Scale Type/Unit: Meter-ABNT]