forum.datacad.com

I don't actually batch plot much so I hope I'm not missing anything but:

1. I would like to change the destination folder on the fly rather than having to always retrieve them from the PlotFiles folder and stick them in the job. I recognise that I can make the change in the preferences, but that is as on the fly as I would like.

2. I would like a preview option in the process. I would happily take the speed hit to get the peace of mind.

Nick Pyner wrote:1. I would like to change the destination folder on the fly rather than having to always retrieve them from the PlotFiles folder and stick them in the job. I recognise that I can make the change in the preferences, but that is as on the fly as I would like.

You can hit the little folder icon to the left of the Print To File(s) check box to set the output location.

Ah... That's a relief.
Thanks