Using Identify to select a smart door or window doesn't display the opening width (length) of the window or door, only it's height and z-b/z-h values. Can the following be considered for inclusion:
1. opening width of the window or door,
2. sill height with smart windows,
3. When using Identify-Set All and selecting a smart wall, have the 'draw walls on/off' toggle (=) turn ON so smart walls are ready to be created. Currently, if you're in a 2D mode and I-Set All on a smart wall and continue drawing, you're still in a 2D mode drawing lines instead of smart walls.
Thanks.
1. opening width of the window or door,
2. sill height with smart windows,
3. When using Identify-Set All and selecting a smart wall, have the 'draw walls on/off' toggle (=) turn ON so smart walls are ready to be created. Currently, if you're in a 2D mode and I-Set All on a smart wall and continue drawing, you're still in a 2D mode drawing lines instead of smart walls.
Thanks.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com