What features would you like to see added to a future version of DataCAD?
#71303 by Mark Bell
Sun Apr 23, 2017 4:50 am
2D Rotate stores the previous centre of rotation allowing you to exit the command, do other editing and then go back into Rotate and pick Previous Center to continue where you left off. 3D Rotate, however, doesn't allow this.

Wishlist - add Previous Center to 3D Rotate

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984