What features would you like to see added to a future version of DataCAD?
#71525 by Mark Bell
Sun May 21, 2017 5:53 pm
Hi John,

If you go to an isometric view, then pick V to access the 3D Views menu, then F8 Control, then F2 World axis, then regen to fit to screen, then pick F0 or S1 to rotate clockwise/counterclockwise by the preset angle (S4 Rot. Angle). This will allow you to rotate the model to get the views you mention.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984