Each time the Render Settings / Sunshader / Filters setting is used to omit selected entity types in Sunshader (ie. cylinders which cause excessive shadow lines), then Sunshader is launched and exited, the settings reset themselves and have to be reset again prior to going back into Sunshader. This happens every time Sunshader is closed.
Wishlist 1 - have the Filter settings retain their selection on a per drawing basis.
Wishlist 2 - fix the issue with cylinders so the excessive shadows are no longer a problem.
Wishlist 1 - have the Filter settings retain their selection on a per drawing basis.
Wishlist 2 - fix the issue with cylinders so the excessive shadows are no longer a problem.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com