Using symbols with KO over fills, hatching and also closed polylines etc. works great, but if the closed polyline also applies a knockout then the symbol is always placed beneath it even when 'move to back' is used for the closed polyline / move to front for the symbol and the closed polyline is on a layer further up the layer menu.
Wishlist - allow symbols with KO to work with move to front/back so they can be visible over closed polylines which also have KO applied.
Wishlist - allow symbols with KO to work with move to front/back so they can be visible over closed polylines which also have KO applied.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com