What features would you like to see added to a future version of DataCAD?
#73045 by Mark Bell
Tue Jan 09, 2018 11:33 pm
Currently, selecting Render Settings/Entity Type filter then say cylinders to exclude it from being imported into Sunshader, will provide a cleaner looking image when shadows are turned on. However, after exiting Sunshader the selections are reset and needs to be done again each time Sunshader is used. I use SS almost as much if not more than O2C as it gives a better image to check the design progress. Having DataCAD remember the selections made in the Render Settings would be most useful.

Who is online

Users browsing this forum: No registered users and 5 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984