forum.datacad.com

When toggling between plan and elevation views the crosshair remains set at the last B-Tangents angle of the current view. If there are angled walls or a rotated plan and the crosshair is set at an angle, the crosshair remains at this B-tangent angle when switching to an elevation view. Similarly, if the crosshair is set at the pitch of a roof and the view toggles back to plan, the crosshair remains at the roof pitch B-tangents angle.

Wishlist - add view dependent crosshair angles (B-tangents) that allow a separate B-tangent view to be set up in both plan and elevation views. When each view is made active, the crosshair will switch to the angle set in that view.

Hello Dave,
To be honest I'd overlooked that feature as I've been working 'live' between views without saving them. If there's a way to implement this without first saving the views that would be useful. If not, at least there's a workaround to having the crosshair remember it's screen setting using saved views.
Thanks.

Hello Dave,
You must have been reading my thoughts as I began using the MVW's yesterday as an alternative only to realise they don't (yet) support remembering crosshair alignment either. Adding this to the MVW.s would certainly be useful.
Thanks.

Thank you Dave, once again.