forum.datacad.com

The example below is of a smart wall which has brickwork on the outside with the end caps set to match the outside walls. Gyprock is on the inside. Rather than create duplicate walls with alternate end caps set to match the inside wall finish, which would add dozens and dozens of extra wall types to accomplish this, can we:

1. Add a toggle to the crtl-right click Wall Properties menu that allows the end cap material type to be modified on a per-selection basis.

Mark Bell wrote:...
1. Add a toggle to the crtl-right click Wall Properties menu that allows the end cap material type to be modified on a per-selection basis.

The problem restricting my ability to do this is that the cap material is a property of the Wall Type, not the wall entity itself.

Dave

Okay, thanks anyway for considering it.