What features would you like to see added to a future version of DataCAD?
#74125 by Mark Bell
Thu Jun 14, 2018 10:07 pm
Currently, when Identifying an open or closed polyline the whole polyline is selected with Area and Perimeter the only measurements shown in the readout.

Add the ability to also show the length of the line segment (or arc length with curves), between the two nearest nodes in either direction. This allows a polyline to be 'read' similar to standard lines and can allow, say, a site boundary outline to be defined as a polyline (so areas can be quickly verified), as well as allowing any length along any segment of the boundary line to also have its length read in the readout at the bottom of screen.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984