David A. Giesselman wrote:Mark Bell wrote:There's times when a mirror line is needed between two points on a drawing. Bisect isn't always able to work due to the types of entities selected. Being able to pick Mirror/F3 Midpoint would allow a user to snap to any two points then DataCAD can set the crosshair at 90' to the alignment.
Could you accomplish this by object-snapping to the two points in the drawing to define the Mirror line, and then select Add 90 Ctr to rotate the Mirror line about its midpoint by 90 degrees?
I have done this a fair bit. The refinement I have sometimes used is to hold Shift and Get X / Y for the second point, to be sure it is an orthographic line. Occasionally, the selected points are not exactly lined up, and the mirror line is slightly skewed.