Currently, if a hatch origin is applied, then the hatch is moved or mirrored, the hatch origin remains in its designated screen location.
Wishlist. Allow the option for Hatch Origin's to remain associated to the hatch pattern rather than the screen location. This would then allow hatch origin points assigned to various hatch patterns to "follow" the hatching whilst retaining the same origin points relative to the hatch pattern, just in a different screen location than originally applied. This then allows the user to move whole bits of information to different areas of the screen whilst retaining the same relative hatch origin points.
Wishlist. Allow the option for Hatch Origin's to remain associated to the hatch pattern rather than the screen location. This would then allow hatch origin points assigned to various hatch patterns to "follow" the hatching whilst retaining the same origin points relative to the hatch pattern, just in a different screen location than originally applied. This then allows the user to move whole bits of information to different areas of the screen whilst retaining the same relative hatch origin points.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com