Hello,
Is there a possibility to increase capabilities from the stamp feature ?
Let's say that I could create a link among a 'stamp' on a table and an entity or an information 'catched' in the drawing.
The stamp creation could start by the 'Ctrl+Right click', catching any proprierties of the entity.
My wish, indeed is that any change on those 'attached' proprierties would be updated in the stamp.
Thanks,
Miguel
Is there a possibility to increase capabilities from the stamp feature ?
Let's say that I could create a link among a 'stamp' on a table and an entity or an information 'catched' in the drawing.
The stamp creation could start by the 'Ctrl+Right click', catching any proprierties of the entity.
My wish, indeed is that any change on those 'attached' proprierties would be updated in the stamp.
Thanks,
Miguel
Miguel J. Palaoro • Porto Alegre • Brasil
[DataCAD user since V.4 • Languages: English & Português • Scale Type/Unit: Meter-ABNT]
[DataCAD user since V.4 • Languages: English & Português • Scale Type/Unit: Meter-ABNT]
(That's good 
)
