There appears to be 2 options with smart wall hatching - either have the hatch a consistent direction relative to the drawing screen or set to match the wall angle. The problem arises if the smart walls are rotated 'odd' angles which results in the hatching either staying at the same angle relative to the drawing screen, or if match wall angle is on, the hatch angle is retained for each separate wall as shown below. It can also result in some walls not displaying any hatching due to the wall and hatch angles aligning.
Wishlist - add a Lock Hatch Angle so the hatch remains consistent across all walls even when the walls are rotated rather than having the hatch angle remain fixed.
preference to have Match Wall Angle deselected
Match Wall Angle deselected and walls rotated with hatch remaining fixed relative to drawing screen - would prefer the option to have the hatch also rotate with each wall
Match Wall Angle selected but results in hatching being in various directions on a per wall basis
Wishlist - add a Lock Hatch Angle so the hatch remains consistent across all walls even when the walls are rotated rather than having the hatch angle remain fixed.
preference to have Match Wall Angle deselected
Match Wall Angle deselected and walls rotated with hatch remaining fixed relative to drawing screen - would prefer the option to have the hatch also rotate with each wall
Match Wall Angle selected but results in hatching being in various directions on a per wall basis
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com