It's been noticed that if the Symbol Browser is open and a symbol in a drawing is edited to open it in its own drawing window (ctrl-right click and Edit), the time taken to 'release' the crosshair can be 'lengthy' if the SB has many symbols in the open folder. If the on-screen symbol is nested, then opening each successive symbol in its own DSF window duplicates this 'lag' time before the crosshair is released. It appears each time a symbol is opened in its own DSF window, the SB refreshes all symbols inside the open folder, and when there are many symbols this causes the delay?
Wishlist - in situations where a symbol is opened in its own DSF window, remove the Refresh of the open SB. It's not needed when editing a symbol or nested symbol. This should remove the delays in waiting for the crosshair to release, noted above.
Wishlist - in situations where a symbol is opened in its own DSF window, remove the Refresh of the open SB. It's not needed when editing a symbol or nested symbol. This should remove the delays in waiting for the crosshair to release, noted above.
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com