Quite often, there's a need to move multiple blocks of MSP sheets to make space to insert new sheets whilst retaining the correct drawing sheet order for easy referencing and printing. The current problem is that moving MSP sheets can only occur one at a time, and if more sheets are needed towards the top of the list then all remaining sheets below need repositioning one by one - which is tedious and time consuming.
As an alternative to moving sheets to make space for new sheets, add the ability to select any two MSP sheets to insert another sheet or multiple sheets in between.
As an alternative to moving sheets to make space for new sheets, add the ability to select any two MSP sheets to insert another sheet or multiple sheets in between.
Neil Blanchard likes this
DataCAD user since v4!
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com
Regards
Mark Bell
Principal
ATELIER MARK BELL
Australia
https://www.ateliermarkbell.com