What features would you like to see added to a future version of DataCAD?
#81549 by Joseph Baron
Thu Sep 29, 2022 12:55 pm
Recently I worked with a clients drawing and they use Bearings as their default Angle Type. When I changed that to my default Dec Degrees I had to stop and figure out what was happening because 0 degrees was still pointing up the screen.

It's a very minor thing to set the Start Angle every time (I get a file, set to Dec Degrees to work on it, reset the Start Angle, set it back to Bearings to send it back) but is it possible to have the Angle Type set to the DEFAULT DIRECTIONS when selecting an Angle Type?

For example when I select 'Normal' can we get it to reset 0 to be going to the right? If Bearings was previously selected 0 is still pointing up the screen.
Attachments
DataCAD Normal Angle Type.jpg
DataCAD Normal Angle Type.jpg (13.62 KiB) Viewed 18680 times

Who is online

Users browsing this forum: No registered users and 34 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984