forum.datacad.com

Is it possible to identify group to prevent to move, to copy or to rotacionar bad details?

Greetings Arthur,

This is an excellent idea! It would seem to be a natural fit to add a "Show Group" button in the otherwise sparsely used Group menu?

While I agree that this is a good idea, a work around is to use drag group to verify the group, if you are not sure. I use this all the time. But again, I agree that this would be a good idea.

Neil Blanchard wrote:...to be a natural fit to add a "Show Group" button in the otherwise sparsely used Group menu.

Good idea.

Got my vote too.

Thanks,
Miguel