A button to repeat the last command, like save symbol, hatch by boundry, etc. This button can be turned off so the erase command erases only a single time, then a new command must be entered. Many commands are already sticky, like erase, change, etc. but some are not. I would like to have more say in which commands are sticky.
curtschultz wrote:A button to repeat the last command, like save symbol...
You are right. This is a good suggestion. It was this way on previous releases using templates.
...hatch by boundry...
This is already working sticky on 11.08.01
...This button can be turned off so the erase command erases only a single time, then a new command must be entered...
Sorry, don't agree with you. I prefer the way as it is in DataCAD. You can exit a command by right clicking at any place. It is much more probable that you use a command in more then one time that the opposite.
And remember that you always can use the 'transparent' access, generaly on toolbar icons, which can use built-in function numbers. It allows the prompt return to the previous command is use.
Thanks,
Miguel