New Internal Function Code
Posted: Sat Mar 05, 2005 10:09 am
Hello,
Is possible to add an internal function code to "Isometric" in 3D Views ?
I wish to have a transparent root to this command, which helps a lot to show the 3D model. A direct access code could add easiness to the stream 2D edition.
Thanks,
Miguel
Is possible to add an internal function code to "Isometric" in 3D Views ?
I wish to have a transparent root to this command, which helps a lot to show the 3D model. A direct access code could add easiness to the stream 2D edition.
Thanks,
Miguel