What features would you like to see added to a future version of DataCAD?
#14661 by Bev
Wed Nov 01, 2006 4:35 pm
My wish is that the MSP sheets would not be dependent on the last setup used. If a sheet is set up to print on 36x24, it should not see that the last time I plotted a detail I used an 8 1/2 x 11 for a quick plot. I should be able to set up some sheets to be 36 x 24 and some to be 8 1/2 x 11 and some to be 18 x 24 if I desire.

Layout also should not be dependent on rotation. Today when I set up my sheets to be 30x42 rotated and later changed rotation to be "normal", I had to reposition all my "details". :(

When I set up a sheet to be 36 x 24 and save the file, and my co-worker opens the file and it shows up as 42 x 30 or 48 x 36 this is bad. Also when they set up a sheet to be 36 x 24 and save it, when I open up the sheet it should not show it to be 24 x 18. When it is set up, it should stay set up no matter what drivers are installed on a computer.

I should be able to set up my sheets to plot 36 x 24 and when in the drawing if I want to print just a small portion, I should be able to do a quickplot on 8 1/2 x 11 or 11 x 17 or whatever I want without changing my sheets. :)

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984