What features would you like to see added to a future version of DataCAD?
#19283 by Jon C. Hubart
Thu Jan 25, 2007 2:15 pm
I'm not sure how easy this is to fix, but...

If you create a master polyline and then create two void polylines and add them to the master polyline, the area is calculated subtracting the area of the two voids from the area of the master polyline. This is fine until you lap the voids on top of each other.

If you hatch the polyline you will see distinct areas of hatch and non-hatch. The area calculation should return a value that represents all areas that are diplaying hatch. It should calculate the overlapping areas of the voids and add this value back into the total area.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984