Hello,
When you are editing a polyline (dragging or adding vertex), and 'Info' is ON, you get a report with the value of the Perimeter and Surface Area, which are done dinamically.
In certain cases, if you are dragging an "Edge" you could be needing to look for an adjusted "Value" for this 'Area'.
Would be possible to prompt the user to be allowed to fill a "Value" for the 'Area', and get the position stick on the exact point ?
Thanks,
Miguel
When you are editing a polyline (dragging or adding vertex), and 'Info' is ON, you get a report with the value of the Perimeter and Surface Area, which are done dinamically.
In certain cases, if you are dragging an "Edge" you could be needing to look for an adjusted "Value" for this 'Area'.
Would be possible to prompt the user to be allowed to fill a "Value" for the 'Area', and get the position stick on the exact point ?
Thanks,
Miguel
Miguel J. Palaoro • Porto Alegre • Brasil
[DataCAD user since V.4 • Languages: English & Português • Scale Type/Unit: Meter-ABNT]
[DataCAD user since V.4 • Languages: English & Português • Scale Type/Unit: Meter-ABNT]