forum.datacad.com

Hi,

The DataCAD interface allows you to add voids to a polyline, but I cannot find anything in the DCAL manual regarding polyline voids (except that they are mentioned indirectly in the definition of pline_centroid procedure, but the example code for that just reads multiple entities and assumes some of them are voids)

Does anybody know if it is possible to add polyline voids using DCAL ?

Thanks,
David H

In 2007 Devinder wrote "We have different routines to get polyline voids, but those have not been externalized as of yet. I will externalize them for next DCAL update."
I assume this has not in fact been done (or the next DCAL update has not happened yet) ?