Hi,
The DataCAD interface allows you to add voids to a polyline, but I cannot find anything in the DCAL manual regarding polyline voids (except that they are mentioned indirectly in the definition of pline_centroid procedure, but the example code for that just reads multiple entities and assumes some of them are voids)
Does anybody know if it is possible to add polyline voids using DCAL ?
Thanks,
David H
The DataCAD interface allows you to add voids to a polyline, but I cannot find anything in the DCAL manual regarding polyline voids (except that they are mentioned indirectly in the definition of pline_centroid procedure, but the example code for that just reads multiple entities and assumes some of them are voids)
Does anybody know if it is possible to add polyline voids using DCAL ?
Thanks,
David H
David Henderson
dhSoftware - Add-on Macros for DataCAD
dhSoftware - Add-on Macros for DataCAD