I've decided to undertake the process of learning DCAL with the help of the online Tutorial on the DataCAD website.
When testing the setup, it says to go to Command Prompt and type in DCC TEST. Ok. Nothing. However, if I run DCC1 and DCC2 seperately I get the results that I should get when running DCC. What gives?
Thanks in advance for any help.
PS - Anybody want to suggest a nice, simple programming editor other than text editor like Notepad. I've seen many freeware and shareware programs but would like suggestions from someone who has used them.
When testing the setup, it says to go to Command Prompt and type in DCC TEST. Ok. Nothing. However, if I run DCC1 and DCC2 seperately I get the results that I should get when running DCC. What gives?
Thanks in advance for any help.
PS - Anybody want to suggest a nice, simple programming editor other than text editor like Notepad. I've seen many freeware and shareware programs but would like suggestions from someone who has used them.
Ben Ledbetter, Project Manager
Thomas J. Brennan Architects
Frisco, Texas
972.867.3948
ben@brennanarchitects.com
Revit 2020, DataCAD 18, SketchUp 2019, Lumion 8.5
Surface Pro 4 i7 2.2GHz 16GB, iPAD Pro
Thomas J. Brennan Architects
Frisco, Texas
972.867.3948
ben@brennanarchitects.com
Revit 2020, DataCAD 18, SketchUp 2019, Lumion 8.5
Surface Pro 4 i7 2.2GHz 16GB, iPAD Pro