Does anybody know of a way to insert a stamp like the "Path+Name+Extension" (@DWGFULLNAMEEXT) stamp into a symbol, so that when the symbol in inserted into a drawing unexploded, the stamp will show the path to the symbol it was inserted from, not the drawing it's inserted into. Using the @DWGFULLNAMEEXT stamp in the symbol, and then double clicking on the symbol to edit it the stamp shows the path to the symbol while editing, probably because it's really a drawing at that point I'd guess. I tried a few things like @DSFFULLNAMEEXT and @SYMFULLNAMEEXT with no luck. If this is not possible yet, I hope it's something do able that could be added at some point. TIA.
I am still trying to figure out a way to do the above. Is there somewhere I can look at a list of the available codes we can use? It looks like the pre-made stamps are using DCAL Procedures, is this correct? Or are we limited to using the user created stamps which are limited to simple text substitution set by the UserChangeTo_1= line or using combination of the pre-made stamps?
At this point I would settle being able to open a symbol for editing, insert the DwgFullName=@DWGFULLNAME stamp which at that point works, and being able to "expand" it to dumb text and then save the symbol with normal text. I tried plugging in some newer symbol related procedures from StudioPM's Raw DCAL Notes as I found dwgname listed there and in the old Funclist.doc but I couldn't seem to get any results. If it's not possible on my end as of now that's fine. TIA for any ideas.
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.