I received this message 'stack overflow' when I tried compile with DCC in Windows XP Home Edition. Support DCAL answer:
"
Hello Vicente:
Please refer to the updated tutorial on the DDN site. DCC.EXE is not compatible with the command prompt in Windows.
Instead…
Type,
DCC1 TESTE
Then type,
DCC2 TESTE
Finally type,
DCL TESTE;
You should be able to compile your test macro using these three separate steps.
DCAL Tutorial
https://www.datacad.com/ddn/tutorial/dcal_tut.htm
Thank You,
MFM
Who is online
Users browsing this forum: No registered users and 46 guests