My engineer is reporting that symbols are merging all items to layer "0".
In Program Preferences, DXF/DWG, the box is unchecked next to "Merge Symbol Layers to layer "0"".
Same in Export Dialog box.
Where else might there be a setting for this?
In Program Preferences, DXF/DWG, the box is unchecked next to "Merge Symbol Layers to layer "0"".
Same in Export Dialog box.
Where else might there be a setting for this?
Roger Donaldson AIA CSI CDT LEED AP BD+C NCARB
abUsing Datacad since 1986, ver 22.00.01.00 (SE)
http://www.RogerDonaldsonArchitect.com
abUsing Datacad since 1986, ver 22.00.01.00 (SE)
http://www.RogerDonaldsonArchitect.com