Forum dedicated to drawing translation issues.

Moderator: David A. Giesselman

#59617 by WK3
Tue Mar 19, 2013 2:57 pm
I have imported a dwg file into DataCAD 12. The text comes in as Mtext. Is there a way to set the conversion to bring the text in as Paratext instead?

Is there a way in DataCAD to change Mtext to Paratext other than copy/paste one at a time?

Is there a way in DataCAD to globally make changes, like font, text content, and alignment, to Mtext instead of selecting each one at a time?
#59619 by REX PEET
Tue Mar 19, 2013 7:32 pm
On some occasions Autocad text comes in as Mtext, on others as broken up into polylines, with squillions of entities. Anything would be a vast improvement
#60184 by wvar
Tue May 07, 2013 8:53 pm
Surely there must be a way to do what WK3 asks. Can it be done as an 'ini' option?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984