Page 1 of 1

converting dwg multi-line text

PostPosted: Tue Mar 19, 2013 2:57 pm
by WK3
I have imported a dwg file into DataCAD 12. The text comes in as Mtext. Is there a way to set the conversion to bring the text in as Paratext instead?

Is there a way in DataCAD to change Mtext to Paratext other than copy/paste one at a time?

Is there a way in DataCAD to globally make changes, like font, text content, and alignment, to Mtext instead of selecting each one at a time?

Re: converting dwg multi-line text

PostPosted: Tue Mar 19, 2013 7:32 pm
by REX PEET
On some occasions Autocad text comes in as Mtext, on others as broken up into polylines, with squillions of entities. Anything would be a vast improvement

Re: converting dwg multi-line text

PostPosted: Tue May 07, 2013 8:53 pm
by wvar
Surely there must be a way to do what WK3 asks. Can it be done as an 'ini' option?