Hi again
The drafter of one of my problem files wrote back:
"I’m using AutoCAD Lt. 2005. This as far as I know doesn’t contain any third party software. I do however explode my borders because I have them saved as a block. I put the border into the drawing and explode it so I can add the client information. I haven’t had anyone else have a problem with my files though. "
Does this help?
FYI- I also tried opening it in DCAD10, no luck
Thanks! - Josh
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.
Do. Or do not. There is no try.
Josh's Digital Downloads is come back online soon. Stay tuned.
Hi Neil-
Hope your presentation went well. I sent the file to Datacad as you suggested and Mark found the problem:
"The problem is related to 54 lines in the drawing that are extremely
long - somewhere in the neighborhood of 1.5826E+99 feet in length. 30
of these lines are on the layer "A-GLAZ-ELEV-FRAME" and another 24 are
on the layer "A-GLAZ-ELEV-GRILLE."
Unfortunately, there is no way to find out if that is the problem unless the sender can check the drawing. But I hope this at least helps others with similar importing issues!
Hope your presentation went well. I sent the file to Datacad as you suggested and Mark found the problem:
"The problem is related to 54 lines in the drawing that are extremely
long - somewhere in the neighborhood of 1.5826E+99 feet in length. 30
of these lines are on the layer "A-GLAZ-ELEV-FRAME" and another 24 are
on the layer "A-GLAZ-ELEV-GRILLE."
Unfortunately, there is no way to find out if that is the problem unless the sender can check the drawing. But I hope this at least helps others with similar importing issues!
Keep on scrolling.............
I haven't worked it out precisely but I reckon a line that long reaches to the next galaxy. And you thought it was a DataCad problem.
I haven't worked it out precisely but I reckon a line that long reaches to the next galaxy. And you thought it was a DataCad problem.
Nick Pyner
Dee Why Beach NSW
Dee Why Beach NSW
Who is online
Users browsing this forum: No registered users and 27 guests