Forum dedicated to drawing translation issues.

Moderator: David A. Giesselman

#66299 by cblair
Fri Apr 24, 2015 1:42 pm
I am in receipt of some SAVE AS files from Vectorworks: DWG and DXF from each of the above releases. When importing into a empty AEC file (17.02.00.09 SE) in Windows 7 DataCAD closes after a few seconds of importing. I wonder if there are tricks or tips from anyone that I may employ. While trolling this board it seemed that perhaps I should try importing directly from the VW file without using the SAVE AS..... I will try that.
#66300 by MtnArch
Fri Apr 24, 2015 5:20 pm
You might try running the DWG/DXF through AutoDesk's DWG TrueView and save it back out before importing it into Dcad.
#66308 by MtnArch
Mon Apr 27, 2015 5:27 pm
There are other Acad clones that you could try as well, but most (if not all) of them require payment - but I don't believe DWG TrueView costs anything.

Good luck!

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984