Forum dedicated to drawing translation issues.
#79964 by cblair
Thu Jul 29, 2021 10:07 am
After I've imported by engineers drawing, say 25 layers, all the S (Snap Grid) are ON for all layers. Any to globally change them to OFF? At the moment I
tab through the drawing turning each off. A bit of a pain. Thank you.
#79965 by Roger D
Thu Jul 29, 2021 10:18 am
Try using GridLock macro, turn on all layers, turn off grid snap and then begin.

Gridlock (GRIDLOCK.ZIP, 1KB, 02/99) Get Source
Locks every layer's grid settings to the current active layer grid settings.
https://www.datacad.com/support/down/Gridlock.zip

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984