forum.datacad.com

I can create the files no problem, but when I try to open them in the viewer I have, it says they won't open.

I have not changed anything, though I did add the sketchup export and [beta] section along with the pak n go stuff.

The thing is my cow-orker created files back in mid march that has the same problem.

Anybody else run into this?

Greg

In what format did you save the files, i.e. R12, R13, R14, R2000? What format does your viewer support?

R2000

the viewer supports up to 2008 I believe.

I'm thinking it's the viewer as I had some buddies that use AutoCAD test out an export I did. They had no problem with it.