forum.datacad.com

I am using Datacad LT 11. I am trying to open a .dwg I received via email. I save the file to my Datacad drawings file, then try to open it in Datacad. The program feezes while "Analyzing". I have to force close the program. I then restart the program, try to open the file again, and receive a "Cannot open file. File Decompression Error: 105". I can open other .dwg's from other sources without problems. Is this a problem with the file I am receiving? Can the sender change a setting on his end so I can open it?

Greetings,

Is this DWG larger than the others? Possibly you are running up against the file size limit of DataCAD LT? If you like, you could email me the file, and I could send you back a v11 AEC -- if it is too large for LT, I could purge unused symbols, etc. to make it small enough to work for you. Send me a PM and I'll give you my email address.