Support on o2c files (Objects 2 See) and o2c Interactive!
#80583 by cadline
Fri Jan 21, 2022 12:06 am
Morning,
Please consider adding a layer switch within the O2C interactive viewer.
It will be great to be able to switch layers on or off without having to exit O2C and do the same in DataCAD

Regards, Eugene
#80585 by Mark Bell
Fri Jan 21, 2022 4:07 am
cadline wrote:Morning,
Please consider adding a layer switch within the O2C interactive viewer.
It will be great to be able to switch layers on or off without having to exit O2C and do the same in DataCAD

Regards, Eugene


.....or, as another possible enhancement, add the ability to sync the active O2C window with the DataCAD model so there's no need to close the O2C window and then re-launch it. If changes are made in the DataCAD model then press an Update/Sync button on the O2C window to update the O2C model. This would allow users to keep designing and simply sync the O2C window when needed to refresh it with the latest changes made in the DataCAD model. You can sort of do this now using a MVW with auto update turned on. Being able to do this with an O2C window would be great.

Who is online

Users browsing this forum: No registered users and 4 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984