Support on o2c files (Objects 2 See) and o2c Interactive!
#80977 by dksargert
Sun Jun 05, 2022 3:29 pm
Greetings, Its been a while....(I posted this in Ver22 also)
Just upgraded from DCX3 to DC22 and am frustrated with the operation of o2c.
I can get it to run the FIRST TIME on both simple and VERY Complex Models (in grey tones) but it crashes EVERY TIME when opening the second time regardless of the simplicity of the model! (ie a simple cube and sphere)
This is a production killer!
I'm sure it's a "setup thing" from my end but I'll be darned if I can figure out why this would be happening?
Any thoughts appreciated.
DKS

PS - I also tried to open several o2c models produced earlier directly and these too crash o2c as a stand alone - SO FRUSTRATING!
#80989 by dksargert
Tue Jun 07, 2022 4:53 pm
it has been determined that my crashes in Ver 22 with o2c were due to me ALSO having o2c Interactive installed. I uninstalled o2c interactive and am back in the clear!'
Thank you Clay at LLC

Who is online

Users browsing this forum: No registered users and 6 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984