Support on o2c files (Objects 2 See) and o2c Interactive!
#49842 by Nick Pyner
Fri Aug 20, 2010 8:24 pm
We have been trying to put a picture on a polygon, in much the same manner as one would in Renderise Live.

The poly is the same proportion as the picture.

The picture is split, with the right hand third to the left of the frame.

The verftical scale is about right but this was trial and error. The horizontal scale is off, resulting in a bit mising at the edge.

Is there a procedure to sort this out? I wondered if it might have something to do with absolute zero.


Image

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984